Sony HXC-D70 User Manual page 15

d WHITE BAL (white balance memory select) switch
Control adjustment of the white balance.
PRST: Adjust the color temperature to the preset value (the
factory default setting: 3200K). Use this setting when you
have no time to adjust the white balance.
A or B: Recall the white balance adjustment settings already
stored in A or B. Push the WHT/BLK switch (see
page 14) on the WHT side, to automatically adjust the
white balance, and save the adjustment settings in
memory A or memory B.
When this switch is adjusted, the new setting appears in the
viewfinder for about three seconds.
Unavailable when the camera is connected to the CCU.
e GAIN selector
Switch the gain of the video amplifier to match the lighting
conditions during shooting. The gains corresponding to the L,
M, and H settings can be selected in OPERATION > SWITCH
ASSIGN 1 > GAIN L/H/M in the setup menu (see page 59).
(The factory settings are L=0 dB, M=6 dB, and H=12 dB.)
When this switch is adjusted, the new settings appear in the
viewfinder for about three seconds.
Unavailable when the camera is connected to the CCU.
f DISPLAY/MENU switch
Select the display in the viewfinder.
DISPLAY: To display various textual information and markers,
such as messages showing the camera settings and
operating status, the center marker, and the safety zone
marker, in addition to camera images.
OFF: Not to display textual information and markers.
MENU: To display menus for camera settings, in addition to
camera images.
The switch functions the same as the DISPLAY/MENU switch
on the rear operation panel.
g "Memory Stick Duo" slot and access lamp
Take the cover off and insert a "Memory Stick Duo" into the
slot. The access lamp lights in green.
The lamp is lit in red while writing/reading data to/from the
"Memory Stick Duo."
Notes
• Only a "Memory Stick" of Duo size can be used with the
camera.
• When the access lamp is lit in red, do not remove the
"Memory Stick Duo" or turn off the camera.
• The cover cannot be closed while a "Memory Stick Duo" is
inserted into the slot.
h STATUS/CANCEL switch
STATUS: To display status information of this camera in the
viewfinder when no menu is displayed with the DISPLAY/
MENU switch set to DISPLAY.
CANCEL: To cancel changed settings or return the display to
the previous menu when a menu is displayed in the
viewfinder.
Rear
LINE MIC +48V
EARPHONE
PUSH PUSH
DC IN
INTERCOM AUDOIO 2 IN
* The figure above illustrates a camera without its rear cover.
For information on removing the rear cover, see "Removing the
Rear Cover" (page 22).
a TALLY (back tally) indicators (red/green)
ON: The tally lamp lights when a tally signal is input to the
connected CCU or a call signal is generated in response
to pressing of a CALL button.
OFF: The tally lamp is prevented from lighting.
b TALLY switch
Set to ON to activate the TALLY indicator function.
c Menu control knob (rotary encoder)
This knob functions the same as that on the front panel (see
page 14).
d DISPLAY/MENU switch
This switch functions the same as that on the right panel (see
page 15).
e CALL button
When you press this button, the red tally lamps on the front
panel of the CCU and the connected external control device
(RCP/RM, etc.) will light.
Locations and Functions of Parts and Controls
TEST
SDI OUT
OUT
REMOTE
SDI IN
PROMPTER
DC OUT
/GENLOCK
15