Network Settings (Lan); Network Settings (Wlan) - Bang & Olufsen BeoSound 5 Encore Installation Manual

Perform Basic Wireless Settings
> In Wireless -> Basic Wireless Settings select 'Manual' and the following:
5 GHz Wireles Settings
Network Mode:
Channel:
SSID Broadcast:
> Click Save Settings (Continue) and select Wi-Fi Protected Setup™
Change the wireless security passphrase
The purpose of changing the password is to secure the network against
unauthorized access. This is important no matter if using LAN connection or WPS
encryption.
> Click on Wireless and Wireless Security
and 2.4GHz).
hexadecimal digits. Only WEP, WPA and WAP2 is supported encryption standards
> Click on the Save Settings button to store settings.
Change the router password
It is highly recomended to change the default password (admin) to increase the
security of the network.
> Click on the tab Administration.
> Click on the tab Management
> Click on the Save Settings button to store settings.
From this point, the installer must continue the installation by choosing which kind of network connection BeoSound 5 Encore is connected to:
Basic Wireless Settings with the settings below:
2.4 GHz Wireless Settings
:
Mixed Network Mode:
Auto (DFS) Channel:
Enabled SSID Broadcast:

Network settings (LAN)

Network settings (WLAN)

:
Wireless-G only
Auto
Enabled