Bang & Olufsen BeoSound 5 Encore Installation Manual page 15

NETWORK SETTINGS
Check network connection
By default the product is set to obtain network settings such as IP address and
Protocol). In this case it is not necessary to make network settings.
Follow the procedure below to check the network connection:
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS, and press GO.
> Use the pointer to highlight NETWORK INFO.
If not, NETWORK SETTINGS must be made manually (see illustration here).
! If the IP address says 127.0.0.1, and NETWORK CONNECTION = NO, the product
was not assigned the correct IP address via DHCP.
address, subnet mask, gateway and DNS addresses, they must be assigned
manually. Follow the procedure below:
> Turn the wheel to select SETTINGS, and press GO.
> Use the pointer to highlight NETWORK SETTINGS.
> Turn the wheel to select DHCP, and press GO.
> Turn the wheel to select DISABLED, and press GO (now the greyed out items
> Fill in the IP ADDRESS, SUBNET MASK, GATEWAY and DNS SERVER manually
> Use the pointer
NETWORK SETTINGS.
MODE
SOUND
HOSTNAME BeoSound5-Encore-xxxxxxxx
SYSTEM SETTINGS
MAC ADDRESS 00-09-A7-00-C1-09
DHCP ENABLED
IP ADDRESS 192.168.100.X
MAINTENANCE
SUBNET MASK 255.255.255.0
GATEWAY 192.168.100.1
DNS SERVER 8.8.8.8
NETWORK CONNECTION YES
SERVICE SETTINGS
WIFI STATUS DISABLED
WIFI ACCESS POINT WIFI ACCESS POINT NOT CONFI...
WIFI LEVEL 0 dBm
NETWORK INFO DHCP
WIFI QUALITY 0 dBm
IP ADDRESS
NETWORK SETTINGS
SUBNET MASK
GATEWAY
ROLES
DNS SERVER
NETWORK CONNECTION
WIFI STATUS
DHCP
IP ADDRESS
MODE
SOUND
SUBNET MASK
SYSTEM SETTINGS
MAINTENANCE
GATEWAY
SERVICE SETTINGS
DHCP
PRODUCT INFO
DNS SERVER
IP ADDRESS
NETWORK INFO
SUBNET MASK
NETWORK SETTINGS
GATEWAY
ROLES DNS SERVER
ENABLED
192.168.100.X
255.255.255.0
192.168.100.1
8.8.8.8
YES
DISABLED