Dimming Curves; Blackout Or Hold If Dmx Signal Stops - Martin PAR 2 RGBW Zoom User Manual

To set a fixture's DMX channel mode:
1. Select CHANNEL MODE and press ENTER.
2. Use the DOWN and UP buttons to select the desired DMX mode and
press ENTER to set (or, to return to the higher level of the menu
structure without making a change, press MENU).

Dimming curves

Four dimming curves are available:
DIMMER 1: LINEAR – The increase in light intensity appears to be linear
as DMX value is increased.
DIMMER 2: SQUARE LAW – light intensity control is finer at low levels
and coarser at high levels.
DIMMER 3: INVERSE SQUARE LAW – light intensity control is coarser
at low levels and finer at high levels.
DIMMER 4: S-CURVE – light intensity control is finer at low levels and
high levels and coarser at medium levels.
DIMMER 1
To set the fixture's dimming curve:
1. Select DIMMER and press ENTER. The currently set mode will blink in
the display.
2. Use the DOWN and UP buttons to select DIMMER1, DIMMER 2,
DIMMER 3, or DIMMER 4.
3. Once the mode has been selected, press ENTER to set (or, to return to
the higher level of the menu structure without making a change press
MENU).

Blackout or Hold if DMX signal stops

You can decide how the fixture should behave if you are controlling the
fixture via DMX and you stop sending the DMX signal.
1. Select BLACKOUT and press ENTER. The currently set blackout mode
will blink in the display.
RUSH PAR 2 RGBW Zoom™ User Manual
DIMMER 2 DIMMER 3 DIMMER 4
17