Using And Replacing The Surface Light - KitchenAid KGRT507 Use & Care Manual

U
sing and

Using and replacing the surface light

(Some freestanding models)
The surface light is in the backguard. It is
controlled by the Surface Light Command
Pads on the control panel. The ON
Command Pad turns on the light immediately
and keeps it on until you press OFF. The
NIGHT Command Pad will turn on the
surface light automatically when the light in
the room is low enough to require a night
light. When the night light comes on, it will
also dim all lights appearing on the display.
Press OFF to turn off the regular surface light
or press NIGHT again to turn off the night
light.
To turn on the surface light:
PRESS
To turn off surface light:
PRESS
To turn on night light:
PRESS
"NIGHT LIGHT" shows on the display when
the night light is on.
To turn off night light:
PRESS again
16
C Y
aring for our
C
ooktop
Replacing the surface light:
1. Unplug range or disconnect power.
2. Flip up the top of the backguard.
3. Pull up glass on front of backguard.
4. Grasp the fluorescent light tube at both
ends. Turn the tube approximately 90°
in either direction until both ends come
out of the receptacles. Replace with a
20-watt cool-white fluorescent light tube.