Using And Replacing The Surface Light - KitchenAid KGRT507B Use And Care Manual

"Using and Caring for Your Cooktop
Using and replacing the surface light
(Model KGRT507B)
The surface light is in the backguard. It is
controlled by the Surface Light Command
Pads on the control panel. The On Com-
mand Pad turns on the light immediately and
keeps it on until you press OFF. The Night
Command Pad will turn on the surface light
automatically when the light in the room is
low enough to require a night light. When
the night light comes on, it will also dim all
lights appearing on the display. Press OFF
to turn off the regular surface light or press
NIGHT again to turn off the night light.
Replacing the surface light:
1. Unplug appliance or disconnect at
main power supply.
2. Flip up the top of the backguard.
To turn on the surface light:
PRESS
To turn off surface light:
PRESS 3. Pull up glass on front of backguard.
To turn on night light:
PRESS
!,_II:J_'_.Tei4fll[_J=illl
"NIGHT LIGHT" shows on the display when
the night light is on.
To turn off night light:
PRESS again
S_rlr}_J_.,_#if_e_Ti
4. Grasp the fluorescent light tube at both
ends. Turn the tube approximately 90 °
in either direction until both ends come
out of the receptacles. Replace with a
20-watt cool-white fluorescent light tube.
continued on next page
19