Page 1
KITCHENAID CONSUMER SERVICES Technical Training Department Failure Codes & Wiring Diagrams KitchenAid Freestanding & Slide-In Ranges And Built-In Ovens All rights reserved. No portion of this document may be reproduced in any form without written permission from Whirlpool Corporation. Part No. 4317266...
FAILURE CODES Control out of calibration: F F F F F 1 1 1 1 1 F F F F F 5 5 5 5 5 Door signal inconsistent: • Place the sensor in ice water • Open and close the door to see if (32˚F) and check the resistance the oven light responds.
Page 13
UNIVERSAL FAILURE & ERROR CODES F F F F F 1 1 1 1 1 = Electronics Subsystem Failure. Replace the electronic control board. E0 = EEPROM communication error. E1 = EEPROM checksum error. E2 = A/D converter error (is there an error bit in the microprocessor?; does this mean lost a voltage rail?) E3 = Configuration jumper (cavity size or gas/electric) does not match setting defined in EEPROM (this was designed to notify the installer that the jumpers were not...