Alc1024 With Eec Overview; Alc1024 With Ethernet Extension Card Overview; Features Of The Alc1024 With The Ethernet Extension Card - ZyXEL Communications ALC1024 User Manual

This section introduces the ADSL line card and its factory default settings when it is used with the
2.1

ALC1024 with Ethernet Extension Card Overview

The following features and default settings apply to configuration and management of the ADSL line card when
you use it with the EEC (Ethernet Extension Card). Refer to Chapter 1 ALC1024 Overview for a general
introduction to the ALC1024 and features, default settings and hardware specifications that apply to the line card
whether it is used with the management switch card or the Ethernet extension card.
2.2 Features of the ALC1024 with the Ethernet Extension
Card
These features apply to the ADSL line card when you use it with the Ethernet extension card.
Bridging
•
IEEE 802.1D transparent bridging
• Up to 4096 MAC entries address table
• Port-based VLAN (Virtual Local Area Network)
IEEE 802.1Q Tagged VLAN
Your ADSL line card uses the IEEE 802.1Q Tagged VLAN (Virtual Local Area Network), which allows your
device to deliver tagged/untagged frames to and from its ports. The line card supports up to 255 VLANs and the
maximum VLAN ID 4094.
Fast Mode
The fast mode makes use of the "tag" subset of the IEEE 802.1Q standard to identify the source port of a frame
and speed traffic through a service gateway.
MAC (Media Access Control) Filtering
The line card can filter incoming frames based on MAC (Media Access Control) address(es) that you specify. You
may enable/disable specific ports. You may specify up to five MAC addresses per port.
Secured Host
Allow up to ten remote hosts to access the line card via IP addresses you specify.
System Error Logging

ALC1024 With EEC Overview

ALC1024 with EEC Overview
ALC1024 Overview
Chapter 2
Ethernet extension card.
2-1