Chapter 10 Ip Commands; Ip Commands Overview; Setting The Ip Address; Figure 10-1 Setting The Ip Address Sequence - ZyXEL Communications ALC1024 User Manual

10.1

IP Commands Overview

More often than not, you have more than one DSL line card for a particular installation. The IP host
implementation in the line cards allows you to manage them over the network. Use the commands in this chapter
to configure the line card's Internet Protocol settings. Before you start configuring these settings, make sure that
you:
1. Plan ahead.
2. Have a complete diagram showing the whole network.
3. Record the IP parameters assigned to the equipment in your network.
10.2

Setting the IP Address

To set the IP address, default gateway and the subnet mask of the Ethernet port of a line card, use the following
command sequence.
1.
2.
3.
4.
5.
where
<new ip address>
<default gateway>
Line 1 brings you to the IP subsystem.
Line 2 allows you to add a new IP address for the line card. The IP address of the line card is displayed in the
command prompt. The system automatically computes the subnet mask when the system is restarted. If you want
to specify a subnet manually, add the following two commands before line 3:
192.168.1.1 ip> subnet delete ether.home
192.168.1.1 ip> subnet add ether.home ether <subnet address> <subnet mask>
where <subnet mask> is the subnet mask in hexadecimal, for example "
Line 3 deletes the existing default route.
IP Commands
192.168.1.1> ip
192.168.1.1 ip> enable ether <new ip address>
<new ip address> ip> route delete default
<new ip address> ip> route add default 0.0.0.0 <default gateway> 00:00:0
<new ip address> ip> config save

Figure 10-1 Setting the IP Address Sequence

=
The IP address you want to configure for the line card.
=
The default gateway IP address of the line card.
This chapter shows you how to configure the IP parameters.
Commands with EEC
Chapter 10
IP Commands
".
ff:ff:ff:00
10-1