ZyXEL AG-320 User's Guide
The following table describes the operation of the LINK and ACT LEDs on the rear of the
device.
Table 2 AG-320 LEDs
LED
LINK
ACT
1.2 Application Overview
This section describes some network applications for the AG-320.
1.2.1 Station Mode
The AG-320 is in wireless station mode by default. When the AG-320 works as a wireless
station (wireless client), you can either set the network type to Infrastructure and connect to
an AP or use Ad-Hoc mode and connect to a peer computer (another wireless device in Ad-
Hoc mode).
1.2.1.1 Infrastructure
To connect to a network via an access point (AP), set the AG-320 network type to
Infrastructure using the Profile screen. Through the AP, you can access the Internet or the
wired network behind the AP.
24
STATE
DESCRIPTION
On
The AG-320 is receiving power.
Off
The AG-320 is not receiving power.
Blinking
The AG-320 is sending or receiving data.
Off
The AG-320 is not sending or receiving data.
Chapter 1 Getting Started