Application Overview; Infrastructure; Table 2 Nwd-170N Leds - ZyXEL Communications NWD-170N User Manual

ZyXEL NWD-170N User's Guide
The following table describes the operation of the PWR and LINK LEDs on the device.

Table 2 NWD-170N LEDs

STATE
The PWR LED is off
The PWR LED is blinking
The PWR and LINK LEDs are
blinking alternately.
The PWR and LINK LEDs are
blinking simultaneously and
regularly.
The PWR and LINK LEDs are
blinking simultaneously and
irregularly.

1.2 Application Overview

This section describes some network applications for the NWD-170N. You can either set the
network type to Infrastructure and connect to an AP or use Ad-Hoc mode and connect to a
peer computer (another wireless device in Ad-Hoc mode).

1.2.0.1 Infrastructure

To connect to a network via an access point (AP), set the NWD-170N network type to
Infrastructure. Through the AP, you can access the Internet or the wired network behind the
AP.
20
DESCRIPTION
The NWD-170N is not receiving power.
The NWD-170N is receiving power.
The NWD-170N is not connected to a wireless network.
The NWD-170N is connected to a wireless network.
The NWD-170N is connected to a wireless network and is sending
or receiving data.
Chapter 1 Getting Started