ZyXEL AG-100 Quick Start Guide Important Note Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 3
ZyXEL AG-100 Quick Start Guide This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The installation procedures are similar for all supported Windows versions. Windows XP screen shots are shown unless otherwise specified. DO NOT insert the ZyXEL AG-100 at this point. 1. Insert the support CD into the CD-ROM drive on your computer. The installation program will automatically run.
Page 5
LED side facing up, slide the ZyXEL AG-100 into the slot. The LEDs turn on if the ZyXEL AG-100 is properly inserted. Never bend, force or twist the ZyXEL AG-100 into the slot. 7. Windows will automatically install and configure the AG-100 8.
ZyXEL AG-100 Quick Start Guide 9. Double click the icon to configure your wireless adapter. If the ZyXEL Utility icon displays, the ZyXEL AG-100 is installed properly. Refer to the User’s Guide to configure the ZyXEL AG-100. Power Link The following table describes the LEDs on the ZyXEL AG-100.
ZyXEL AG-100 Quick Start Guide PROBLEM Windows does not Make sure the ZyXEL AG-100 is properly inserted into the auto-detect the CardBus slot and then restart your computer. Once the ZyXEL AG-100. computer has restarted, check the status of the LEDs on the ZyXEL AG-100.