192.168.1.1 ip> config [save]
This command shows the IP configuration. The save option saves the configuration to the nonvolatile memory.
10.3.2
Version Command
Syntax:
192.168.1.1 ip> version
This command shows the firmware version and date on the line card.
10.3.3
Ping Command
Syntax:
192.168.1.1 ip> ping <host> [<ttl> [<size>]]
where
host
=
ttl
=
size
=
This is an IP facility to check for network functionality by sending an echo request to another IP host and
waiting for the reply.
10.3.4
Statistics Command
Syntax:
192.168.1.1 ip> stats <sub cmd>
This command shows the statistics for the traffic of the type specified by the sub-command. Statistics are
available for the following traffic types: ARP, ICMP, IP, raw, TCP and UDP.
10.3.5
Subnet Add Command
Syntax:
192.168.1.1 ip> subnet add <net name> <i/f name> a.b.c.d am:bm:cm:dm
where
<net name>
<i/f name>
a.b.c.d
am:bm:cm:dm =
IP Commands
The IP address of the target.
Time to Live (optional). This parameter limits the number of hops (routers) that the
echo request can travel before it reaches the target.
The parameter specifies the size of the payload, that is, not counting the headers, of the
echo request. The default size is 32 octets.
=
Define the name of the subnet for identification purposes.
=
The name of an interface ("ether" for this device).
=
The subnet's IP address.
The subnet's subnet mask.
Commands with EEC
10-3