Extron electronics IN1606 Setup Manual page 4

Command
Select audio and video input
Select video input only
Select audio input only
Execute Auto-Image
Execute Auto-Image and fill
Execute Auto-Image and follow
Set scaler output rate
Mute video to black
Mute video and sync
Unmute video and sync
NOTE:
By default, adjusting variable volume with the following commands only affects variable analog output (see the IN1606 and IN1608
Series User guide to configure the variable volume through group masters).
Set variable volume level
Raise variable volume
Lower variable volume
View variable volume level
NOTE:
By default, setting the audio mute with the following commands affects all outputs (see the IN1606 and IN1608 Series User guide to
configure the master audio mute through group masters).
Set master audio mute
View master audio mute status
Enable executive mode 1
Enable executive mode 2
Disable executive modes
Set screen saver mode
Set screen saver time-out duration
View screen saver status
Set scaler IP address
Set scaler DHCP mode
Set subnet mask
Set gateway IP address
Reboot networking
NOTE:
IP settings will not take effect until the
NOTES:
X!
= Input selection (1-6)
X(
= Enable or disable (0 = off or disabled; 1 = on or enabled)
X2#
= Screen saver sync time-out duration (0 = instant time out; 1-500 = in 1 second increments; 501 = never)
X2&
= Screen saver mode (1 = black output [default]; 2 = blue output)
X3*
= Screen saver status (0 = active input detected; 1 = no active input, timer running; 2 = no active input, timer expired, output disabled)
X4) = IP address (xxx.xxx.xxx.xxx; 192.168.254.254 = default)
X4!
= Subnet mask (xxx.xxx.xxx.xxx; 255.255.0.0 = default)
X4@
= Gateway address (xxx.xxx.xxx.xxx; 0.0.0.0 = default)
X4$
= Group volume level (-1000 to 0, where -1000 = -100 dB or 0% volume and 0 = 0 dB or 100% volume)
X4* = Increment value (dB value multiplied by ten, in 0.1 dB increments, to raise or lower a group fader [for example, 100 = 10 dB])
X5$
= Output rate (see the table on page
Extron USA Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners.
4
ASCII Command Response
(Host to Device) (Device to Host)
X! X! •
! In
X! X! •
& In
X! X! •
$ In
A Img0
1*A
Img1
2*A
Img2
EX5$ }
RATE Rate
1B Vmt1
2B
Vmt2
0B
Vmt0
}
E X4$
D8* GRPM GrpmD08*
E D8* X4* +GRPM }
GrpmD08*
E X4* }
D8* -GRPM
GrpmD08*
E } X4$]
D8GRPM
E X( }
D7* GRPM GrpmD07*
E D7GRPM } X(]
1X
Exe1
2X
Exe2
0X
Exe0
E M X2& SSAV } SsavM
E X2# }
T SSAV SsavT
E } X3*]
SSSAV
EX4) }
CI Ipi
EX( }
DH Idh
EX4! CS } Ips
EX4@ }
CG Ipg
E }
2BOOT Boot2
E }
2BOOT command is executed.
3 or the IN1606 and IN1608 Series User Guide)
Extron USA - West: +1.714.491.1500
Extron USA - East: +1.919.850.1000
Additional Description
]
All Selects audio and video input
]
RGB Selects the video only input
]
Aud Selects the audio only input
Executes Auto-Image on the current input.
]
] Executes Auto-Image and fills the output.
] Executes Auto-Image and maintains the aspect ratio of
the current input.
X5$] Specifies an output resolution and refresh rate.
Mutes the video and displays a black output.
]
] Mutes the video and sync output.
Unmutes the video.
]
]
X4$ Set the variable volume to a value of
]
X4$ Increase the level of the variable volume by
]
X4$ Decrease the level of the variable volume by
View the current variable volume level.
X(] Enable or disable master audio mute.
View the current master audio mute status.
] Locks out the entire front panel.
Locks the front panel except for input selection and
]
volume control.
] Allows all front panel adjustments and selections.
Set the screen saver mode.
X2&]
X2#] Set the screen saver sync time-out duration.
View the status of the screen saver.
• X4)] Specifies a new scaler IP address.
X(] Enables or disables DHCP.
Specifies a new subnet mask.
• X4!]
• X4@] Specifies a new gateway IP address.
Restarts the network after IP or DHCP changes.
]
FAX: +1.714.491.1517
FAX: +1.919.850.1001
X!
.
X!
.
X!
.
X4$
.
X4*
dB.
X4*
dB.
www.extron.com
68-2290-50
Rev. B
06 13