Operation - Special Features; 100 User Programmable Rx Channels; Manually Programme A Rx Channel - Uniden UH8080S Owner's Manual

Operation - Special Features

100 User Programmable RX Channels

The UH8080S has 100 receive only channels (CH81 to CH180) which can be
programmed with frequencies ranging from 400-520MHz (in 12.5kHz steps). The extra
RX channels only appear, as part of the CB channel bank, when a frequency has been
programmed to a channel. There are three ways to programme RX channels;
1. If you know the frequency you may manually programme it to a channel.
2. Store a Police or Fire (& Ambulance) frequency to a channel.
3. Use the Close Call RF Capture feature to find a nearby strong signal & store this
frequency to a channel.
Furthermore, the RX channels can be Alpha Tagged (given a name) if desired.

Manually Programme a RX Channel

In CB channel mode (UHF CB channel);
1. Press & hold [MENU]. The lowest available empty RX channel will flash.
2. Press /
3. Press [SQL] to begin the frequency edit. The MHz digit range flashes.
Use or to shift between MHz range (between 400-520MHz) & kHz range (in
12.5kHz steps).
Press /
4. When desired frequency is entered press [SQL] to move to Alpha Tag selection. A
cursor flashes in the 1st alpha position.
If you do not wish to name the channel then skip this step.
Press /
Use or to shift between cursor positions.
5. When finished press [SQL]. A long confirmation tone sounds to indicate the new
channel is programmed.
The channel flashes to enable selection for programming of next channel if desired.
6. Press and hold [ENTER], or wait for 10sec, to exit programming mode.
UNIDEN UH8080S
if you wish to select another RX channel.
to select the desired frequency within MHz & kHz ranges.
to select the desired alpha character.
31
UHF CB Transceiver