Model 7035B Specifications - HP -7035B Technical Manual

PERFORMANCE
Input Range: 1, 10, 100 mV/in.; 1 and 10 V/in. (Option 001,
Metric calibration:
4 V/cm). Continuous vernier between ranges.
Type of Input: Floated and guarded signal pair. Input may be
operated up to ±500 Vdc with respect to chassis ground.
Signal and guard terminals are available at the front panel
or at a rear connector. Mating rear connector supplied.
Input Resistance:
Range
1 mV/in. (0.4 mV/cm)
Variable
10 mV/in. (4 mV/cm)
Variable
100 mV/in. (40 mV/cm)
Variable
1 V/in. (400 mV/cm)
Variable
10V/in. (4 V/cm)
Variable
Maximum Allowable Source Resistance: 20k ohm on most
sensitive range, no restriction on other ranges.
Normal Mode Rejection (at line frequency): > 30 dB (18
dB/octave roll-off above 60 Hz).
Common Mode Rejection: Conditions for the following data are
DC or line frequency AC with up to 1K ohm between the
positive input and negative input, and the negative input
connected to the guard terminal. Maximum allowable DC
or DC plus peak AC common mode voltage is 500V.
1-2
TABLE 1-1. MODEL 7035B SPECIFICATIONS
0.4, 4, 40, 400 mV/cm
Input Resistance:
Potentiometric.
(essentially in-
finite at null)
11k
100k
100k
1 meg
1 meg
1 meg
1 meg
1 meg
1 meg
Range
Standard
and
1 mV/in.
10 mV/in.
100 mV/in.
1V/in.
10 V/in.
Slewing Speed 20 in/s, 50 cm/, nominal at 115V line.
Accuracy: ±0.2% of full scale.
Linearity: ±0.1% of full scale.
Resettability: ±0.1% of full scale
Reference Stability: Continuous electronic zener reference with
temperature stability better than 0.002%/degrees C.
Zero Set: Zero may be placed anywhere on the writing area or
electrically off scale up to one full scale from zero index.
Adjustable by a locking ten-turn, high resolution control.
Writing Mechanism: Servo actuated ink pen.
Writing Area: 7 in. X 10 in. (18 cm X 25 cm).
Paper Holddown: Autogrip electric paper hold-down grips
charts 8-1/2 in. X 11 in. or smaller. Special paper is not
required.
Pen Lift: Electric pen lift with provision for remote control.
Power: 115 or 230 V ± 10%, 50 to 60 Hz, approximately 45 W.
Weight: Net, 18 lb (8 kg; shipping, 24 lb (10.9 kg)
Metric DC (CMR)
0.4 mV/cm 130 dB
4 mV/cm 110 dB
40 mV/cm 90 dB
400 mV/cm 70 dB
4 V/cm 50 dB
GENERAL
AC (CMR)
100 dB
80 dB
60 dB
40 dB
20 dB