Operation Guide Of Tw1 Unit; Pre-Assigned Function Modes By Remote's Buttons; Programmed Function Modes By A Short Press Of Button [ I ] - Code Alarm TW-1 Owner's Manual

. . J
)
Operation guide of TW-1
This is devised for easy operation just by somel fixed functionl by buttons and
Imovable cursor meansj. Users can choose the desired function just by first popping
out the cursor and then
moving
it on to the related function Position.
There are total 3 buttons marked with [ I ' II ' ill] on the remote unit. The [ I ' II]
buttons are used in alarm function mode setting and the third [ill] button is used in
popping out and
moving
of the cursor on to the desired function position.
*
Pre-assigned function modes by remote's buttons
Remote's button [I]: Press and hold this for engine-start and shutoff
Remote's button [ II] : Press and hold this for trunk release.
Remote's button [I] [ II] : Press and release both [ I ] & [II] simultaneously for
car find.
Remote's button [1][ II ]: Press and hold both [ I ]
& [
II ]simultaneously for remote
panic
*
Programmed function modes by a short press of button [ I ]
Press and release this to
activate
self-defined function .It is generally programmed for
door lock/unlock. Other functions can also be programmed as below:
Step 1: Press button [ill] twice or more times quickly to pop up the cursor.
Move
the
cursor to the desired position by pressing button [ill] a number times as
~
necessary. For example,
move
the cursor on to r t::;I
J
position, if you want to
have
"Audible Arm Mode" function activated by a short press of button [ I ] .
Step 2: When the cursor reaches the desired position, press and hold [ill] again for 6
sec till the remote unit sounds the first 2 and final 3 beeps. From then on, press
and release button [ I ] to
activate
the selected function.
*
To re-define the function of button [ I ]re-do the procedure from procedure step (1)
&
(2).The previously-defined function mode will be substituted by the last definition.
4