Programmable Function By Over-Ride Switch; Page-Out Call - Code Alarm TW-1 Owner's Manual

/-)
19.
I
Programmable functions by over-ride switch
I
The TW-1 programmable functions are [valet, daily auto-start
time ,temperature-controlled auto start] these all can be programmed for ON/OFF
modes by means of over· ride switch in the following procedure.
(a) , Turn the ignition OFF
(b) • Press and release the over-ride switch for assigned number of times to acquire
desired mode settings [3 times for valet change mode setting] , [4 times for daily
auto-start time setting] , [5 times for temperature-controlled auto-start setting]. The
number of siren's chirps follow the equal number press on the over-ride switch to
confirm the current mode setting.
(c), Turn the ignition ON when the desired mode setting is reached. (engine must not be
running)
(d) • To choose the ON and OFF in each mode, setting, press again the over-ride switch
1 or 2 flm-es The factory default setting is marked with shaded description like OFF.
Manual features program table
No of presses on over-ride switch VS Single press Double
active mode setting presses
3 times to enter valet mode setting· ON
OFF
4 times to enter daily auto-start time mode ON{see note below}
OFF
setting
5 times to get temp-controlled auto start time ON OFF
mode setting
Siren and LED indicator 1 2
Note: If the dally auto-start time ON
IS
programmed, the engine Will be running
immediately when the ignition key is turned OFF .( Use the remote LCD unit to shut off
the en ine in this case.)
20. Pa e-out call from car
If page-out call button on vehicle-base antenna case is pressed
0
• The remote unit displays •
81.
on the screen and sounds melody
14