Switch-Controlled Anti-Carjack On/Off; Remote Valet On/Off - Code Alarm TW-1 Owner's Manual

17.!Switch-controlled anti-carjack ON/OFF]
(a) , While the engine is running; press the anti-carjack to activate this function. The
activated anti-carjack mode undergoes 2 stages as below:
(1) In the 1" stage; the parking light flashes for 30 sec.
(2) In the
20d
stage; in the next 30 sec that follows the 1 st stage, there will be another
30 sec alert period during which [(a) the parking light keeps flashing, (b) siren
continues blurting, (c) the engine start circuit is cutoff on until active anti-carjack
mode is cleared]
0
*
At any of the alert stages, choose either (a) or (b) to deactivate the on-going alert.
(a) , To deactivate alert by switch, press and hold for 5 sec the anti-carjack switch (or)
(b)· To deactivate alert by remote unit, press [ill] 2 or more times to pop up the cursor
and move onto
W
@ ~
on the remote unit.
18. ! Remote valet QN /OFF !
(a) • Press [ill] 2 or more times to get the cursor and move onto
[~]
0
(b) • Then press and release [ IT ] to enter valet mode ON. The siren chirps 4 times with
4 flashes of parking light .Under the valet ON mode, all functions are inoperative
except for the remote door unlock and trunk release which are still operable.
( c) • Press and release [IT] again to get valet mode OFF .The main system then
restores all functions back to normal and become operative.
• The remote LCD displays as below :
(d) • While the valet mode is ON, the LCD remote displays
w~ ~
and sounds melody.
(e) • While the Valet mode is OFF, the
W
@ ~
disappears from remote's screen but the
remote sounds melody.
13