Active Channel # 3; Steps Door Unlock /Disarm; Remote Engine Start - Code Alarm TW-1 Owner's Manual

J
/)
J
I
Remote control channel # 3
I
(option program table ]
(a) , If the system is programmed for channel #3 mode ( an external relay is
required)
(b) , Press quickly (ill] twice or more rimes to pop up cursor and then move
W
it onto [B3] )
.
(c), Then press and release [ IT] .The system responses in accordance with
Single
selected function mode .The parking light flashes 3 times for confirmation .
Option
• The remote unit displays Car Status on its screen and sounds 3 beeps
( Choose
I
2 stage door unlock, disarm
I
(option program table ]
only one (a) , If the system is programmed channel # 3 for 2 stage door unlock mode.
of these) ( an external accessory is required)
(b) , Press quickly [ill] twice or more times to pop up the cursor and then
W
move it onto (B3] )
(c) , Then press and release
( IT] to unlock all the doors. The system will
unlock and disarm with 2 siren chirps and 2 parking light flashes.
• The remote unit displays
• U
~
on its screen and sound 2 beeps .
"" Choose one of the above two options and program ·It as required.
4,
I
Remote engine start
I
(a) , The engine is in shut off state.
(b)' Press and hold ( I ] button. Or press IT button when the active cursor is shifted
onto the
d;b
the column. Siren chirps 3 times with 3 parking light flashes when the
engine gets started.
• The remote unit displays 2 stages on its screen as below:
(1) , In the 1
st
stage: The remote unit displays the current status along with
• 51:: ~
while engine is trying for engine start and sounds.
(2)' In the 2
nd
stage: After the engine gets started, the remote unit displays
along with engine's preset run tirne and sounds.
7
-
Ii" ... _ .!l