Using The Remote Control; Installing The Batteries - Strong SRT 6500 User Manual

Using the Remote Control

1. To use the remote control, point it towards the front of the SRT 6500.
2. The remote control has a range of up to 7 meters from the SRT 6500 at an angle of
up to 60 degrees (30 degrees for left hand side, 30 degrees for right hand side).
3. The remote control will not operate if its path is blocked.
Note: 1. Sunlight or very bright light will decrease the sensitivity of the remote
control.
2. Old Batteries will decrease the sensitivity of the remote control.

Installing the Batteries

Remove the battery cover from the remote control and put two AAA size batteries
inside the compartment.
The diagram inside the battery compartment shows the correct way to install the
batteries.
Caution:
1. Keep batteries out of children's reach.
2. Don't attempt to recharge, short-circuit, disassemble, heat or throw the batteries
into the fire.
3. Always replace both batteries at the same time. Never mix new and old batteries or
batteries of a different type.
4. If you don't intend to use the remote control for an extended period, remove the
batteries to prevent possible leakage and corrosion.
5. Do not drop, apply shock or step on the remote control.
6. Do not spill water on the remote control.
Notes: If the receiver does not operate when operating the remote control from a
close range, you need to replace the batteries.
7