6. Use the FMS Joystick to highlight the Calibrate button, press the ENT Key.
7. Ensure that the aircraft has been properly positioned per the on-screen instructions.
8. Use the FMS Joystick to highlight the Calibrate button at the bottom of the display, press the
ENT Key to begin the calibration.
9. The PFD display instructs the operator to gradually increase power from idle to full throttle
and back to idle over the course of a couple of minutes.
G3X Installation Manual – Post Installation Checkout and Calibration Procedures
190-01115-01
Page 9-21
Revision E