10. After the calibration is finished, press the OK Softkey, a Done Key will appear at the bottom
of the display. Ensure that a MAG INTERFERENCE TEST PASSED message appears at the
bottom of the display. The magnetic deviation value is displayed to indicate the pass or fail
margin of the test. Press the ENT Key to return to the GSU Status Page.
Table 9-4. Magnetometer Interference Test Sequence Example
Elapsed Time Since Start
of Test (min:secs)
0:00
0:10
0:20
0:30
0:40
0:50
1:00
1:20
1:40
1:50
2:00
Page 9-14
Revision E
Test begins
Aileron full right
Aileron full left
Aileron level
Elevator up
Elevator down
Elevator level
Rudder left
Rudder right
Rudder center
Flaps down
G3X Installation Manual – Post Installation Checkout and Calibration Procedures
Action
190-01115-01