Phone Line Connections - ADEMCO Symphony Installation And Setup

Advanced user interface

Hide thumbs

Table Of Contents

Table of Contents

4. Connect the (–) terminal of the supplementary power supply to header position 2 (GND

terminal of Symphony/Symphony-i (black wire)).

5. Connect the Data In terminal of the control panel to header position 3 (Data Out

terminal of Symphony/Symphony-i (green wire)).

6. Connect Data Out terminal of the control panel to header position 4 (Data In terminal of

Symphony/Symphony-i (yellow wire)).

7. Connect one end of the Ethernet cable (Category 5) to Symphony/Symphony-i 's RJ45

Ethernet connector and the other end as follows:

If using ...

broadband (e.g. cable modem, DSL, etc.)

narrow band (dial-up modem)

You may want to reference cable wiring information for RJ45 cable. For Category 5 cable pin

outs, refer to the System Interconnection Diagram supplied.

8. Attach the case front of Symphony/Symphony-i to the case back. Attach the top of

Symphony/Symphony-i first, and then press the bottom section inward until it snaps into

place securely.

If using a 9-pin connector, connect the wires to the header as follows:

1. Connect the (+) terminal of the supplementary power supply to header position 1

(+12VDC terminal of Symphony/Symphony-i (red wire)).

2. Connect the (–) terminal of the supplementary power supply and the Gnd terminal of the

control panel to header position 3 (Gnd terminal of Symphony/Symphony-i (black wire)).

3. Connect the +12V terminal of the control panel to header position 2 (+12VDC terminal of

Symphony/Symphony-i (red wire)).

4. Connect the Data In terminal of the control panel to header position 4

(Symphony/Symphony-i Data Out terminal (green wire)).

5. Connect the Data Out terminal of the control panel to header position 5

(Symphony/Symphony-i Data In terminal (yellow wire)).

6. Connect the 485 Video bus wires (if video is available and will be used) to header

positions 8 and 9 (the audio bus terminals of Symphony/Symphony-i).