• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
Initialization
♦
Setting up an Account Number
♦
Symphony/Symphony-i ECP Addressing
♦
How to Change the ECP Address
♦
How to Select the System Options
♦
How to Set the Night Setup Button Function
♦
How to Set Network Connectivity
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Initialization
Power Up Symphony/Symphony-i
When initially powered, the screen displays the boot sequence as it is performed. After it is
determined what services are available, the screen displays the Touch Screen Calibration
screen. Calibrate the touch screen as follows:
SCREEN
♦
How to Setup Network Services
♦
Symphony/Symphony-i Setup
♦
How to Adjust the Touch Screen Contrast
♦
How to Adjust the Volume
♦
How to Select Screen Saver Activation Time
♦
How to Set the Time and Date
1. Within the Touch Screen Calibration screen
you are asked to "Touch the center of the
square displayed in the corner." Press the
center of the square.
When this square is touched the Touch
Screen Calibration screen displays "Next
Point.. Touch the center of the square."
NOTE: If no touch is made within 5 seconds,
"No Touch Detected.. Try Again." is
displayed in the center of the Touch Screen
Calibration screen.
S E C T I O N
Initial Setup
ACTION
4
4-1