Listings And Code Approvals; Specifications; General Information; Parts - Regency U31 Owners & Installation Manual

Gas insert zero clearance kit

Specification sheet (2 pages)

Owners & installation manual (36 pages)

Brochure & specs (24 pages)

Table of Contents

This gas component has been tested in accordance with National Safety Standards, and has been certified by Warnock Hersey

for installation and operation in the United States and Canada as described in these Installation and Operating Instructions.

This gas component has also been tested in accordance with AG103 and certified in Australia by the Australian Gas Association

for installation in Australia, and New Zealand. Install according to AG 103 and as described in these installation and operating

instructions.

Check with your local

building code agency

before you begin your

installation to ensure

compliance with local

codes, including the

need for "permits" and

follow- up inspections. If

any problems are en-

countered regarding

code approvals, or if you

wish clarification on any

of the instructions con-

tained here, contact your

local dealer.

GENERAL INFORMATION

This kit consists of factory built parts that require minimal

assembly to form the Zero Clearance enclosure for the U31/

I31 Gas Insert. The enclosure can then be fixed into a framed

combustible construction, and a standard

"B- vent" (Australia/New Zealand: an approved twin skin flue)

installed on the assembly for the required venting (flueing).

The insert can be installed later.

The faceplate will normally overlap on top of the finished

wall.Using Kit# 410- 905 you can convert the U31/I31 Gas

Insert models into highly efficient heat producing Zero Clear-

ance Fireplaces.

U31/I31 Gas Insert Zero Clearance Kit