Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
Power Up/System Reset
Arming the System
Stay Arming
Stay/Instant Arming
Disarming
Reset
Bypass
Quick Bypass
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Power Up/System Reset
When the system is in an armed state only, it may enter System Stabilization Mode. This
occurs upon power-up of the system, and causes all of the LEDs on the keypad(s) to light, and
then go off for approximately 2 minutes, 10 seconds (if system was previously armed). This
occurs on a total power-up, system reset, or after completion of system programming. If total
system power is lost, upon power restoral, the system returns to the previous arming state.
The 2-minute, 10-second interval is used to allow motion detectors (in interior zones) to
stabilize on power-up in order to prevent false alarms. THIS OPTION CAN BE DISABLED
BY PUTTING A MOMENTARY JUMPER BETWEEN TERMINAL 15 AND 16 ON POWER-
UP. IF DISABLED, THE POWER-UP RESET TIME IS APPROXIMATELY 5 SECONDS.
This is a normal condition.
Arming the System
The system can be armed only if all burglary zones are not faulted. On LED-based keypads,
this requires that the READY LED be on. Arm faulted is only allowed for delay or interior
zones if enabled in programming question 05, location 2.
To arm: Enter any programmed 4-digit user code.
NOTE: The factory default for user code no. 1 is 1234.
The ARM LED lights and the user may exit through an exit/entry zone for the time period
programmed as the exit delay. The system can be armed without the backup battery being
connected; however, the AC/LB LED will flash.
Stay Arming
To arm: Press the [Stay] key followed by a 4-digit user code.
The ARM and Stay LEDs light on LED-based keypads.
The system is armed at this time, with all programmed Stay zones excluded.
System Operations
Exit Bypass
Auto Unbypass
Manual Unbypass
User Code Programming
User Deletion
Keypad Emergency Conditions
Pager Follow-Me Displays
Entering Pager Follow-Me Phone Numbers
S E C T I O N
6–1
6
Hide quick links:
Advertisement
Table of Contents
