Section 6 - System Operations; Power Up/System Reset; Arming The System; Stay Arming - FBII XL-1S Hookup And Installation Instructions

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Power Up/System Reset

SYSTEM STABILIZATION MODE: Upon initial powerup of the system, all of the
lights on the LED keypad(s) will go ON and then go OFF for approximately 2 min.
10 secs and/or the LCD keypad(s) will display STAND BY! for approximately 2 min.
10 secs. This occurs on a total powerup (if ARMED or DISARMED in its prior state)
or after a system reset. If the total system power is lost then upon power restoral,
the system will return to the previous arming state. The 2 min. 10 secs. interval is
used to allow motion detectors (interior zones) to stabilize on power up in order to
prevent false alarms. THIS OPTION CAN BE DISABLED BY MOMENTARILY (5 second
minimum) PUTTING A JUMPER BETWEEN TERMINALS 13 AND 12.

Arming the System

The system can be armed only if all burglary zones are good (not faulted). On LED based
keypads this requires that the READY LED be on.
On LCD keypads the following message will appear:
TO ARM: Enter any programmed four-digit user. NOTE: The factory default for user #1 is
1234.
The ARMED LED will light and the user may exit through an exit/entry zone for the time
period programmed as the exit delay. The system can be armed without the backup battery
being connected, however the AC/LB light will flash.
LCD Based keypads will display:

Stay Arming

TO ARM: Press the STAY BUTTON followed by a four-digit user code.
The ARMED and STAY LEDs will light on LED based keypads.
LCD based keypads will display:
The system is armed at this time with all programmed interior zones excluded.

Instant Arming

TO ARM: Press the INSTANT BUTTON followed by a four-digit user code.
The ARMED and INSTANT LEDs will light on LED based keypads.
LCD based keypads will display:
System Operations
SYSTEM: READY
ON: AWAY
ON: STAY
ON: INSTANT
S E C T I O N
6–1
6