Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
Wiring the OMNI-408A
System Stabilization Mode
Compatible ADEMCO 5800 Series Wireless Devices
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Wiring the OMNI-408A
Refer to the Summary of Connections diagram in Appendix F at the back of this guide for
visual information concerning the wiring and hookup of the OMNI-408A. The connections
shown meet Household Fire / Burglar Alarm System standards set by UL (UL985 and
UL1023).
System Stabilization Mode
Upon initial power-up of the system, all of the lights on the LED keypad(s) will go ON and
then go OFF for approximately 2 minutes, 10 seconds if the system was last armed. This
system stabilization mode occurs on a total power-up, on a system reset, or after completion
of system programming. If the total system power is lost, then upon power restoral the
system will return to the previous arming state. The 2-minute, 10-second interval is used to
allow motion detectors (in interior zones) to stabilize on power-up in order to prevent false
alarms. PUTTING A MOMENTARY JUMPER BETWEEN TERMINAL 15 AND 16 ON
POWER-UP CAN DISABLE THIS OPTION. IF DISABLED, THE POWER-UP RESET TIME
IS APPROXIMATELY 5 SECONDS. This is a normal condition.
Compatible ADEMCO 5800 Series Wireless Devices
•
5802MN Single-Button Transmitter
•
5802CP Belt Clip Panic Transmitter
•
5804 4-Button Transmitter
•
5806 Photoelectric Smoke Detector
•
5807 Photoelectric Smoke Detector
•
5808 Photoelectric Smoke Detector
•
5816 Miniature Transmitter
•
5817 3-Point Transmitter
•
5818 Recessed Magnetic Contact Transmitter
•
5849 Glassbreak Detector
•
5890 Dual-Element PIR
NOTE: The OMNI-408A system is not compatible with the ADEMCO bi-directional devices.
System Wiring and Hookup
Terminal Connections
Auxiliary Device Current Draw Worksheet
S E C T I O N
2–1
2
Hide quick links:
Advertisement
Table of Contents
