Drive Belt; Check Drive Belt Condition; Check Drive Belt Tension - Victory Motorcycles 2005 Ness Signature Series Kingpin Owner's Manual

Drive Belt

Check Drive Belt Condition

Replace the drive belt if it is cracked or has broken teeth or frayed edges. No matter its condition, the drive belt
should be replaced at periodic intervals (see the VICTORY Service Manual or an authorized VICTORY dealer).
NOT attempt to check belt tension if the belt has been exposed to rain or washing within a 24 hour period or if the belt is hot
from riding. Allow the belt to cool down to ambient temperature before measuring belt tension.

Check Drive Belt Tension

This procedure involves using the belt tension gauge, part no. PV-43532,
which is designed specifically for measuring drive belt tension.
Before beginning this procedure:
S Make sure the drive belt is dry and at room temperature.
S Make sure the rear suspension is properly adjusted (see Adjust Rear
Shock Absorber, page 99).
1. Place the transmission in Neutral and lift the rear wheel off the ground
with an appropriate motorcycle lift or a block of wood or steel placed
securely under the frame.
WARNING
Care should be taken to be sure the motorcycle will not tip or fall while elevated. Severe personal
injury or death may occur if the motorcycle tips or falls.
MAINTENANCE
DO
3
1. Belt Tension Gauge
1
2. Small O-Ring
3. Base
4. Plunger
2
4
93