Panasonic Lumix DMC-GM5 Owner's Manual For Advanced Features page 332

13. Others
[Memory Card Error]/[This memory card cannot be used]
•
Use a card compatible with this unit.
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
Insert the card again.
•
Insert a different card.
[Read Error/Write Error
Please check the card]
•
It has failed to read or write data.
Remove the card after turning this unit off. Insert the card again, turn this unit on, and try to
read or write the data again.
•
The card may be broken.
•
Insert a different card.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
•
Perform formatting
•
Insert a different card.
[Motion recording was canceled due to the limitation of the writing speed of the
card]
•
Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures.
•
In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P29).
Depending on the type of the card, motion picture recording may stop in the middle.
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card on this unit after saving necessary data on a PC etc.
If you execute [No.Reset] in the [Setup] menu after formatting, the folder number is reset to
100. (P72)
[Recording stopped due to overheating. Please wait for the camera to cool down.]/
[The Wi-Fi connection will be terminated due to overheating. Please wait for the
camera to cool down.]/[Temporarily disabled. Please wait for the camera to cool
down.]
•
When a high ambient temperature, continuous recording or other conditions cause the
camera to overheat, the following restrictions will occur to protect the camera. Wait until the
camera cools down.
–
Continuous recording, motion picture recording, and the Wi-Fi connection will be
temporarily disabled.
–
If you continue recording even when [
displayed and the camera will turn off automatically.
(P29)
(P29) on this unit after saving necessary data on a PC, etc.
] is flashing on the screen, a message will be
332
(P29)