Table of Contents
Advertisement
11. Using the Wi-Fi function
Sending an image each time a recording is made ([Send Images While
Recording])
1
Select the menu.
> [New Connection] > [Send Images While Recording] > [AV device]
Wi-Fi
2
Select [Via Network] or [Direct], and connect.
3
Select a device you want to connect.
4
Check the send settings, and select [Set].
•
To change the send setting, press [DISP.].
5
Take pictures.
•
To change the setting or disconnect, press [Wi-Fi].
You cannot change the settings while sending pictures. Wait until sending is complete.
(You can also terminate the connection by performing the following operations:
>
MENU
Select and send the images ([Send Images Stored in the Camera])
1
Select the menu.
> [New Connection] > [Send Images Stored in the Camera] > [AV
Wi-Fi
device]
2
Select [Via Network] or [Direct], and connect.
3
Select a device you want to connect.
4
Check the send settings, and select [Set].
•
To change the send setting, press [DISP.].
5
Select [Single Select] or [Multi Select].
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is canceled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi
Select] is limited.
•
Confirmation screen is displayed. It is executed when [Yes] is selected.
•
To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
>
>
[Setup]
[Wi-Fi]
(P294)
(P302)
(P258)
>
[Wi-Fi Function]
[Yes])
(P294)
(P302)
277
Advertisement
Table of Contents
