Convection Fan Blade And Element Replacement; Rack Sensing Switch Replacement - Electrolux EW30DF65GB Service Manual

Electrolux ew30df65g and cewdf65g series freestanding dual fuel range

Hide thumbs Also See for EW30DF65GB:

Use and care manual (64 pages)

Table Of Contents

Table of Contents

The Convection Fan Blade and Element are concealed by the fan cover. Remove the cover as

described on page 33.

The Blade can be removed by using a 13mm

socket wrench to remove the blade retaining nut.

The nut has left hand threads so to remove the nut

turn the wrench in a clockwise direction. (Photo A)

Turn Nut Clockwise

Before removing the convection element

disconnect the element wires which can be

accessed by removing the lower rear shield on the

back of the range. (Photo C)

The rack sensing switch is installed into a cutout in the

oven liner rear wall. (Photo D)

To replace the switch first turn off the power to the

range and remove the lower back cover panel.

Unplug the harness connector (Photo E) and tie a 36

inch length of strong string or cord to the end of the

connector that is attached to the switch. Secure the

other end of the string so that it can not pull all the way

through.

From inside the oven remove the rack sensor assembly

by taking out the two screws at the top and bottom of

the assembly. (Page 32 - Photo B).

Depress the tabs on the switch (Photo D) to release it

from the cutout and carefully pull the switch with the

attached wire harness inside the oven cavity.

Attach the string to the new switch harness and

carefully pull the harness back through the oven liner

and insulation .