Upper Oven Components; Luxury Glide Oven Rack Removal & Maintenance - Electrolux EW30DF65GB Service Manual

Electrolux ew30df65g and cewdf65g series freestanding dual fuel range

Hide thumbs Also See for EW30DF65GB:

Use and care manual (64 pages)

Table Of Contents

Table of Contents

To remove and replace the Luxury Glide oven

racks open the oven door completely. Locate

the spring loaded plunger below the rack

bearing channel on each side of the rack.

(Photo A).

The Luxury Glide Oven Racks have no serviceable parts and should be replaced as a complete

assembly if defective. The ball bearing glide assemblies on the oven racks should be lubricated

annually or more often as needed. Use only the approved water based graphite lubricant.

NEVER use grease or oil of any kind to lubricate the racks or bearings. Approved lubricant is available

through your authorized Electrolux parts supplier under part number 5304468694. This lubricant

should also be used on the rack switch sensor rod assembly

To lubricate the bearings remove the racks as

described in the owners manual. Place the rack on

a protected work surface and slide the rack to the

fully extended position to expose the ball bearing

assembly inside the track. Using the dispenser tip

of the lubricant bottle place a few drops of lubricant

on the top and bottom bearing carriers in the areas

indicated by the arrows in photo C. The lubricant will

be spread to all of the ball bearings as the rack is

operated. Use the lubricant sparingly, a few drops is

all that is necessary.

Repeat this process for each bearing assembly. There are two bearing assemblies on each side of the

rack, one on the inside as seen in the photo and one on the outside. Also lubricate the rack release

plunger mechanism at all friction points as needed.