Bosch VideoJet X10 Installation And Operation Manual page 67

VideoJet X10
5.23.4 Sensitivity (MOTION+ only)
The basic sensitivity of the motion detector can be adjusted for the environmental conditions
to which the camera is subject.
The sensor reacts to variations in the brightness of the video image. The darker the
observation area, the higher the value that must be selected.
5.23.5 Minimum object size (MOTION+ only)
You can specify the number of sensor fields that a moving object must cover to generate an
alarm. This is to prevent objects that are too small from triggering an alarm.
A minimum value of 4 is recommended. This value corresponds to four sensor fields.
5.23.6 Select area (MOTION+ only)
The areas of the image to be monitored by the motion detector can be selected. The video
image is subdivided into 858 square fields. Each of these fields can be activated or
deactivated individually. If you wish to exclude particular regions of the camera's field of view
from monitoring due to continuous movement (by a tree in the wind, etc.), the relevant fields
can be deactivated.
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems
Click Select area to configure the sensor fields. A new window will open.
If necessary, click Clear all first to clear the current selection (fields marked yellow).
Left-click the fields to be activated. Activated fields are marked yellow.
If necessary, click Select all to select the entire video frame for monitoring.
Right-click any fields you wish to deactivate.
Click OK to save the configuration.
Click the close button X in the window title bar to close the window without saving the
changes.
Installation and Operating Manual
Configuration Using a Web Browser | en 67
V3.0 | 2007.09