Changing The Viewfinder Display; Adjusting The Audio Level; Manually Adjusting The Audio Levels Of The Audio Inputs From The Audio In Ch-1/Ch-2 Connectors - Sony PMW-TD300 Operating Instructions Manual

Changing the Viewfinder
Display
You can change the image displayed in the
viewfinder using the VF DISPLAY SELECT
switch. Each time you press the VF DISPLAY
SELECT switch, the display changes in
sequence.
L: Displays the left lens image, in color.
R: Displays the right lens image, in color.
L+R: Displays an overlay of the left lens image
and the right lens image, in color, by
calculating the average for each pixel.
L-R: Displays the image obtained by subtracting
the right lens image from the left lens image
to emphasize the parallax.
3D: Displays the 3D image, in color.
Anaglyph: Displays a superimposed image
obtained by coloring the left lens image red
and the right lens image blue.
3D can be displayed in the supplied viewfinder
only.
Only left or right images can be displayed in DXF
series viewfinders.
In 2D playback mode, the left image is always
used when displaying thumbnails.
Note
The following functions cannot be used when L-R or
Anaglyph is selected.
• Expand focus
• Zebra pattern display
• Peaking display
The following function cannot be used when L+R is
selected.
• Expand focus
64 Changing the Viewfinder Display / Adjusting the Audio Level
Adjusting the Audio
Level
When you set the AUDIO SELECT switch to
AUTO, the input levels of analog audio signals
recorded on each channel are adjusted
automatically. You can also make manual
adjustments.
Note
Even if you set the AUDIO SELECT switch to AUTO,
the input levels of digital audio signals are not adjusted
automatically.
Target audio level for manual audio level
adjustment
Make adjustment using –20 dB as the target level.
If the audio level meter shows a maximum level
of 0 dB, then it indicates that the input audio level
is excessive.
Target input level
Manually Adjusting the Audio
Levels of the Audio Inputs from
the AUDIO IN CH-1/CH-2
Connectors
1
To adjust the signal input to the AUDIO
IN CH1 or CH2 connector, set the
AUDIO IN CH-1 or CH-2 switch to
REAR.
To adjust both input signals, set both
switches to REAR.
Excessive input level