Table of Contents
Advertisement
9
Installing the control panel
This section explains how to install a Logamatic 4000
series control panel and its set of temperature sensors.
DANGER: Risk to life from electric shock.
B Electrical work may only be performed by
professionals with appropriate
qualifications.
B Before opening the appliance,
isolate all poles of the mains power supply
and secure against unintentional
reconnection.
B Please observe all installation instructions.
9.1
Installing the control panel
Fig. 50 shows the control panel and front top cover "A"
from behind.
B Loosen both screws on top of the control panel and
remove the cover. Lift off the terminal cover toward the
top.
Mounting the control panel
B Fit the control panel at the front by inserting the
alignment tabs into the oval holes in the front top boiler
cover.
B Tilt the control panel forward and then tip back.
The flexible hooks must engage with the rectangular
openings at the rear of the front boiler cover.
Logano G615 - Subject to technical modifications
Installing the control panel
B Attach the base of the control panel to the top cover
using two self-tapping screws.
7
6
Fig. 50 Installing the control panel
1
Terminal cover
2
Flexible hooks
3
Rectangular cutouts in the front top boiler cover
4
Alignment tabs
5
Oval holes in the front top boiler cover
6
Cable duct
7
Front top boiler cover
1
2
5
4
3
6 720 615 362-18.2O
9
39
Hide quick links:
Advertisement
Table of Contents
