Table of Contents
Advertisement
IMPORTANT: If at anytime your appliance does not seem to be operating as it had,
CHOOSING MODE OF OPERATION:
Decide on mode of operation:
STEP 1
Manual Operation
Find mode of operation:
STEP 2
(For this example we desire the Manual Operation Mode.)
Press and hold in the OFF button, while you are holding in the off button the following cycle will
NOTE: The Starting Point of the
cycle, depends on what
mode the control was in.
Manual
―You are in
control‖
Lights may be difficult
To see from an angle.
Set mode of operation:
Step 3
To choose the mode you want the board to operate in, simply let go of the OFF button when the
proper lights flash.
Then press the START touch pad to activate the setting.
OPERATING IN MANUAL MODE:
TO START
Press the START touch pad.
Step 1
The control board goes through the entire start up automatically
- Convection (heating) fan will start
(if a speed was selected before)
- The 300 watt Auto-Igniter will begin to glow and the IGNITER
LED will be solid.
- The AUGER CYCLE LED will go solid for 3 seconds, indicating
signal is being sent to the Auger motor.
- Combustion (exhaust) fan will start and operate at full speed for
60 seconds, then the Voltage regulator will adjust fan
PelPro Appliances
O
O
PERATING
PERATING
ALWAYS confirm the mode of operation.
Thermostat On/Off
All 4 Lights
Feed Rates 1 & 4
Only be concerned with the
lights. All others do not effect the mode
selection process.
All 4 Lights
It's that easy!
www.pelprostoves.com
I
I
NSTRUCTIONS
NSTRUCTIONS
or
Thermostat Low/High
Feed Rates 1 & 2
FEED RATE
Feed Rates 3 & 4
Thermostat
On / Off Mode
All 4 Lights
Thermostat
Low / High Mode
22
22
Advertisement
Table of Contents
