Setting Up Your System - Aquathin ASC25K/F Getting Started

reading this manual you will be better able to operate
your new system and perform simple maintenance.

SETTING UP YOUR SYSTEM

Your Aquathin system requires adequate water pressure;
a minimum of 25 PSI (pounds per square inch) of water
pressure is required for the regeneration valve to operate
effectively. The amount of conditioned water produced
depends primarily on your source water hardness and
capacity. Installation to comply with state and local laws
and regulations.
As the Soft&Clean water conditioner system will be in-
stalled on existing plumbing sources; it is important to
ensure that the condition of the existing plumbing is free
from lime and iron buildup. Replace piping that has
heavy lime and/or iron buildup. If piping is clogged with
iron, consult with your local authorized Aquathin Dealer
regarding a separate iron filter unit ahead of the water
softener.
The Aquathin Soft&Clean system requires an uninter-
rupted alternating current (A/C) supply. Please make sure
that the voltage supply is compatible with the unit before
installation. (110V/60Hz or 220V/50Hz for international)
IMPORTANT NOTE:
While installing the Soft-&Clean system, please follow this
cautionary note:

This system is to be supplied with cold water only.

Do not exceed 120 PSI (8.5 bar) water pressure.

Do not exceed 110º F (43º C) water temperature.

Do not subject the unit to freezing conditions.

This system is not intended to be used for treating water
that is microbiologically unsafe or of unknown quality
without adequate disinfection before the system
8 © 2007-2013 Aquathin Corporation. All rights reserved.