If installed outdoors, put down plywood or a concrete
stone in order to provide a flat, even surface for the
SOFT & CLEAN system to be placed upon. (CAUTION:
this unit will crack if allowed to freeze).
4. Connecting the Control Valve to the Resin
Tank
1) Lubricate
the
distributor o-ring
located
by
the
control
valve
throat as shown
in
figure
2.
2) Lubricate
the
tank o-ring seal,
as shown in
fig-
ure 3.
NOTE: use
only silicone lu-
bricant.
3) Attach the pro-
vided upper bas-
ket (bayonet fit)
to
the
control
valve as shown in
figure
4.
12
© 2007-2013 Aquathin Corporation. All rights reserved.
Fig. 2. Lubricate distributor o-ring
with silicone lubricant.
Fig. 3. Lubricate the tank o-ring.
Fig. 4. Make sure the upper basket
locks into place.