8. Connecting the Cable to the Meter Assembly
Connect the cable from the
control valve to the meter
assembly as shown in
11.
The meter assembly of the
SOFT & CLEAN water
conditioning system is sim-
ple and dependable as it
mechanically monitors water usage even during power
failure and initiates regeneration only when needed.
9. Connecting to Drain
Valve
Connect the 5/8 inch black tube
provided to the drain hose barb
as shown in
figure
12.
10. Connecting the Brine Line Flow Control
In order to connect the brine line from the patented Clip
TM
Cabinet
to the main control valve, use the brine line
fittings provided:
a) fitting nut
b) ferrule
c) tube insert
d) brine line screen
16
© 2007-2013 Aquathin Corporation. All rights reserved.
figure
Fig. 11. Firmly insert the
cable in the meter as shown.
Fig. 12. Connect the
drain line as shown
Fig. 13. Place the nut and the
sleeve on the tube, followed by
the tube insert and screen as
shown.
Fig. 14. With the brine fittings
in place, screw the brine line to
the main control valve as
shown.