Identify Water Inlet And Outlet - Aquathin ASC25K/F Getting Started

the provided clips and
tighten the screws as
shown in figure 9.
Doing so, you will be
able to measure and ap-
proximate the required
length of piping from the
bypass valve to the water
source and outlet.
5) Solder joints with caution
Wrap a wet rag around the bypass valve to prevent inter-
nal damage by heat transfer as you proceed with solder-
ing. It is recommended that you leave at least
6" (152mm) between the bypass valve and solder joints
when soldering pipes that are connected on the bypass
valve. Failure to do this can cause interior damage to the
bypass valve.
7. Identifying Water Inlet vs. Outlet
As you stand in front of
the unit, the inlet is on
your right, while the out-
let is on the left. Alterna-
tively, you can look for
the arrow near the bypass
valve outlet indicating
away from the unit, as
shown in figure 10.
15 © 2007-2013 Aquathin Corporation. All rights reserved.
Fig. 9. re-attach the bypass
valve to the main control valve.
Fig. 10. The arrows on the by-
pass valve (as shown) indicate
water inlet and outlet.