Check Flow To Brine Tank; Starting Your System; Plug The Unit To An Electrical Outlet; Set Water Usage Program - Aquathin ASC25K/F Getting Started

(as shown in figure 17) and
allow water to flow at the
drain for 3 or 4 minutes.
4. Check Flow to the
Brine Tank
Manually index the regen-
eration knob to the "brine
fill" position" and allow the
brine tank to fill to the top
of the air check. See
18.
Then manually index the
control knob to the "brine
rinse" position and allow
the control to draw water
from the brine tank until it stops.

STARTING YOUR SYSTEM

1. Plugging the unit into an electrical outlet
Once the installations are completed and you have veri-
fied the tubing and connections, you may plug the system
into an approved power source.
2. Setting the Water Usage Program
To program your SOFT & CLEAN system, first you
must set the time on the unit.
1) To set the time on the unit, refer to
take the following steps:
 First push in the red "time set button"
 Then rotate the 24-Hour Gear so that the "time of
18 © 2007-2013 Aquathin Corporation. All rights reserved.
Fig. 17. Rotate the regenera-
tion knob until in
"backwash" position
figure
Fig. 18. Rotate the knob to
"brine refill" position
figure 19 and