Table of Contents
Advertisement
If piping is clogged with iron, install a separate iron filter
unit ahead of the water softener system.
1) Unscrew the bypass
valve
Unscrew
the
bypass
valve from the main
control valve of the unit
as shown in
figure
6.
2) Solder
pipes
adaptors
According to your local
plumbing
codes,
the
installer must identify
appropriate pipes to be
connected to the bypass
valve.
The pipes must be first
soldered onto the adap-
tors as shown in
figure
7.
3) Screw adaptors into
bypass valve
The adaptors can then
be screwed onto the
bypass valve as shown
in
figure 8.
4) Re-attach the by-
pass valve
Attach the bypass valve onto the main control valve using
14
© 2007-2013 Aquathin Corporation. All rights reserved.
Fig. 6. Unscrew the bypass valve,
to
and remove the adaptor clips.
Fig. 7. Solder the pipes to the
adaptors.
Fig. 8. Screw the adaptors back
on the bypass valve.
Advertisement
Table of Contents
