HP Integrity rx4640 Operation And Maintenance Manual page 185

Step 3. Press the attention button located on the OLX divider that controls the affected slot—the power LED starts to
blink. Wait until the power LED goes from blinking to steady-off.
NOTE
Step 4. Turn the PCI-X card lock on the chassis until the manual retention latch (MRL) is free to pull up.
Step 5. At this point, the power to the slot is off; pull up on the manual retention latch located on the OLX divider. See
Figure 7-22, "PCI-X OLX Divider Layout."
Step 6. Remove the existing PCI-X card from the slot.
Step 7. Push the manual retention latch down until it seats against the chassis wall.
Step 8. Replace the top cover.
Step 9. Push the HP Server all the way back into the rack until it stops.
Online Replacement-(OL-R)
As discussed in the opening section, OL-R is a combination of an OL-D procedure followed by an OL-A procedure.
CAUTION For HP-UX 11i v2 only. You can only replace an existing card with a like card.
To remove and replace a PCI-X card into a populated slot, perform the following steps:
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. See "Accessing a Rack Mounted Server" on
page 141.
Step 2. Remove the top cover from the chassis. See "Front and Top Covers" on page 145.
Step 3. Press the attention button located on the OLX divider controls the affected slot—the power LED starts to blink.
Wait until the power LED goes from blinking to steady-off.
NOTE
Step 4. Turn the PCI-X card lock on the chassis until the manual retention latch (MRL) is free to pull up.
Step 5. At this point, the power to the slot is off; pull up on the manual retention latch located on the OLX divider. See
Figure 7-22, "PCI-X OLX Divider Layout."
Step 6. Remove the existing PCI-X card from the slot.
Step 7. Insert the new PCI-X card into the powered down slot. See Figure 7-23, "Inserting PCI-X Card."
CAUTION
Chapter 7
After pushing the attention button, you have 5 seconds to cancel the operation by pushing the
attention button again.
After pushing the attention button, you have 5 seconds to cancel the operation by pushing the
attention button again.
When inserting the PCI-X card, be careful you do not accidentally touch an attention button on the
other OLX dividers—this will initiate an undesired shutdown of another PCI-X card/slot.
Also, ensure that you fully seat the card into the slot or undesired results may occur after power is
re-applied to the slot.
Removing and Replacing Components
Hot-Plug PCI-X
185