Imaging Problems (For Both Digital And Analog); Imaging Problems (For Digital Only) - Eizo DuraVision FDF2305W User Manual

7-2. Imaging problems (for both digital and analog)

Problem
1. The screen is too bright or too dark.
2. Characters are blurred.
3. Afterimages appear.
4. Green/red/blue/white dots or defective
dots remain on the screen.
5. Interference patterns or pressure marks
remain on the screen.
6. Noise appears on the screen.
7. The screen is whitish or blackish.

7-3. Imaging problems (for digital only)

Problem
1. The color shown on the display is not cor-
rect (for HDMI input).
2. The screen flashes (for HDMI input).
3. The screen is whitish or blackish (for HDMI
input).
Possible cause and remedy
• Use "Brightness" or "Contrast" in the Setting menu to
adjust it (see "To perform advanced adjustments" (page
16)). (The LCD monitor backlight has a limited life
span. When the screen becomes dark or begins to flicker,
contact your local EIZO representative.)
• If the screen is too bright, turn on Auto EcoView and
EcoView Optimizer (see
Automatic Brightness Adjustment "Auto EcoView"" (page
38), "5-4. Reducing Glare "EcoView Optimizer"" (page
38)). The monitor detects the environmental brightness
to adjust the screen brightness automatically.
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor
(see "2-1. Compatible Resolutions/Formats" (page
• Use "Smoothing" in the Setting menu to adjust it (see
modify blurred characters/lines" (page
• Afterimages are particular to LCD monitors. Avoid
displaying the same image for a long time.
• Use the screen saver or power save function to avoid
displaying the same image for extended periods of time.
• This is due to LCD panel characteristics and is not a
failure.
• Leave the monitor with a white or black screen. The
symptom may disappear.
• In the Setting menu, set "Overdrive" to "Off" (see
Overdrive" (page 21)).
• When entering the HDCP signals, the normal images may
not be displayed immediately.
• Use "Black Level" (see "Adjusting the brightness and color
of black "Black Level"" (page
"To adjust contrast" (page
adjust it.
Possible cause and remedy
• Change the color space of the video signal in "Screen" –
"Color Space" under the Setting menu.
• Transmittable signals differ on the category of the HDMI
cable. Check whether the cable support High Speed.
• Use "Screen" – "Color Space" under the Setting menu to
adjust it.
"5-3. Enabling/Disabling
25)).
"Enabling
17)), and "Contrast" (see
17)) in the Setting menu to
Chapter 7 Troubleshooting
13)).
"To
43