Prepare The Transmitter - Flyzone albatros Manual

PREPARE the TRANSMITTER

AA
AA
❏
1. Remove the battery cover on the back of the
transmitter and insert four "AA" batteries. Make sure the
negative ends of the batteries are touching the springs.
TRANSMITTER CAUTIONS
● Do not use rechargeable (NiCd) batteries.
● Do not mix old and new batteries.
● Do not mix alkaline, standard (carbon-zinc) or
rechargeable (NiCd) batteries.
❏
2. Open the charge lead door on the side of the
transmitter and extend the charge lead as shown.
❏
3. Close the door with the charge lead exiting from
the notch in the door. Ensure that the charge lead is not
pinched or severed when the door is reinstalled.
AA
AA
❏
"OFF", connect the battery to the charge lead on the side
of the transmitter.
3
CHARGING the PLANE'S
LiPo BATTERY
IMPORTANT!
NEVER LEAVE A CHARGING BATTERY UNATTENDED!
WARNING!! Failure to follow all instructions could
cause permanent damage to the battery and its
surroundings, and cause bodily harm!
● ONLY use the Micro Albatros transmitter to charge
the LiPo battery.
● ALWAYS charge in a fi reproof location.
● NEVER allow battery temperature to exceed 150°F
[65°C].
● NEVER disassemble or modify pack wiring in any
way or puncture cells.
● NEVER place on combustible materials or leave
unattended during charge or discharge.
● ALWAYS KEEP OUT OF REACH OF CHILDREN.
1. With the power switch on the transmitter set to