Connecting To The Terminal Device Via A Wireless Lan; Connecting In The Wireless Lan Access Point Mode (Ap Mode) - Sony CBK-WA100 Operating Instructions Manual

Connecting to the
Terminal Device via a
Wireless LAN
Connect the wireless adapter and the terminal device via
the wireless LAN.
Connecting in the wireless LAN
access point mode (AP mode)
The wireless adapter works as the access point. Connect
the terminal device to the wireless adapter via the
wireless LAN.
Smartphone/
tablet
Wireless
LAN
module
(not
supplied)
To connect a wireless LAN module to the
wireless adapter
Remove the cover of the USB connector, then connect
the optional wireless LAN module to the USB
connector.
For details of connecting, refer to the supplied
"Installation Manual."
For compatible wireless LAN modules, contact your
Sony dealer or a Sony service representative.
Notes
• Do not connect or disconnect a wireless LAN module
while the wireless adapter is turned on.
• If a wireless LAN module that is not compatible with
the wireless adapter is connected, the STATUS
indicator flashes in red quickly. In this case, connect a
compatible wireless LAN module.
Computer
Camcorder/recorder +
CBK-WA100/CBK-WA101
To connect
1
Set the WIRELESS switch to "AP," then turn the
wireless adapter on.
The wireless adapter starts up in the AP mode.
2
If the terminal device is compatible with the WPS
function:
Press the WPS button for 3 seconds.
The ST indicator flashes in blue.
Note
It takes some time for the ST indicator to flash after
the wireless adapter is turned on.
Perform the following steps within 2 minutes after
pressing the WPS button.
If the terminal device is not compatible with the
WPS function:
Proceed to the next step.
3
Set "Network setting" > "Wireless LAN setting" of
the terminal device to on.
For the wireless LAN setting of the terminal device,
refer to its operating instructions.
4
If the terminal device is compatible with the WPS
function:
Select the wireless adapter's SSID
"DIRECT_taP0:WA100-012345" from the SSID
list, then select "WPS Push Button" from the
options.
If the terminal device is not compatible with the
WPS function:
Select the wireless adapter's SSID
"DIRECT_taP0:WA100-012345" from the SSID
list, then input "abcdefgh" for the password.
Note
The SSID and password of the wireless adapter are
printed on the label of the wireless adapter. The
password can be changed in "AP Settings"
(page 27).
5
Start up the browser on the terminal device, then
access http://192.168.1.1:8080/index.html.
The screen for inputting the user name and
password appears on the browser.

Connecting to the Terminal Device via a Wireless LAN

9