Advertisement
EZW-T100 is a wireless transmitter for Sony S-AIR products, bearing the S-AIR READY logo, or that have an "EZW-T100" slot. You cannot use the EZW-T100 by itself.
In this Operating Instructions, the unit used with this wireless transmitter is called "S-AIR main unit".
Before installing, make sure to remove the AC power cords (mains lead) of all S-AIR products from wall outlets (mains).
Insert the wireless transmitter in the slot on the S-AIR main unit.
For details, refer to the operating instructions of the S-AIR main unit.
The illustration of the rear panel of an S-AIR main unit is an example. Not all S-AIR main units look exactly the same.
Note
Refer also to the Operating Instructions of the Sony S-AIR main unit.
Clean the wireless transmitter only with a soft dry cloth. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzene.
If you experience any difficulties, refer to the Operating Instructions of the Sony S-AIR main unit.
Communication System | S-AIR Specification version 1.0 |
Output | 12.0 mW |
Frequency band | 2.4000 GHz - 2.4835 GHz |
Modulation method | DSSS |
Power requirements | DC 4 V, 550 mA DC 5 V, 15 mA |
Dimensions (approx.) | 52 mm × 24 mm × 95 mm (2 1/8 in × 31/32 in × 3 3/4 in) (max 77 mm × 24 mm × 95 mm) (3 1/8 in × 31/32 in × 3 3/4 in) (w/h/d) |
Mass (approx.) | 61 g (3 oz) |
Design and specifications are subject to change without notice.
"S-AIR" and its logo are trademarks of Sony Corporation.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the S-AIR EZW-T100 that isn't answered in the manual? Leave your question here.