Programming In 7-Day Mode - Danfoss WP75- RF Installation & User's Instructions

Programming in 7-day mode

(separate programmes for each day of the week)
a) Press PROG until Event 1 fl ashes, then
press DAY to move from current day to
Day 1 (Event 1, Day 1).
b) Amend the time and temperature as
follows:
i) Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
ii) Use
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next preset time
and temperature (Event 2, Day 1).
iv) Repeat steps i, ii & iii above for Events 2,
3, 4, 5 & 6.
c) When all 6 events are correct, press DAY
to programme events for Day 2.
(If you wish to repeat the previous day's
programme, simply press COPY) .
d) Repeat steps i-iii above to programme
(or COPY) events for Days 3, 4, 5, 6 & 7.
Press PROG until the colon in the LCD display
starts to fl ash.
The unit is now in RUN mode and your
hot water will come on and go off at the
programmed times.
Proceed to page 16.
14
and buttons to alter the water